LED mounting blocks Culti

Easy installation without screws! With strong self-adhesive tape you can easily mount your LED panels. The blocks are 5 mm thick. Never apply tape or glue directly to the back of the panel — the surface gets hot during use! If you want the panels to be very close to the surface, you need to use screws.

Make the installation of your LED panels simple and quick with our specially designed mounting blocks.
They are equipped with strong self-adhesive tape, so you avoid screws and tools during installation.

The mounting blocks can be used on almost any surface where the self-adhesive tape can stick - both horizontally and vertically. They are particularly suitable for mounting on thin shelves, where the heat from the LED panels could otherwise heat the shelf and cause problems for pots above. This can be especially critical in self-watering pots and hydroponic systems, where too high a temperature in the water tank can damage the plants.

Installation:
The blocks are attached to the keyholes on the back of the LED panels. They should be positioned so that there is approximately 5 mm of air to the edge of the panel when they are pushed into place.

Important to know:
The blocks are 5 mm thick. If you want the panels to sit very close to the wall or ceiling, we recommend that you use the screws provided in your CultiKit instead. The LED panels emit heat on the back, which means that tape should not be applied directly to them.