Powder Feeding – Grow

Designed specifically for the vegetative growth stage of all plants. Its formula provides optimal development throughout the entire growth stage to achieve greener, stronger and more resistant plants.

The growth formula is ideal for the production of mother plants and cuttings. It can also be used very effectively as a foliar feed.

Green House Powder Feeding can be used on all media.

The feeding schedule is slightly different, however, and if you are using something other than soil, we recommend using a PH and EC meter to achieve the desired values
and have full control over your feeding solution.

Easy Grower

If you are growing on fertilized soil, we recommend starting with powder feeding 2-4 weeks after planting the seeds and starting with a mild solution (0.25g per liter).

During the vegetative phase, you can increase the feeding up to 0.5g per liter.

At the beginning of the flowering stage, you should slowly increase the amount of powder feeding until you reach 1g per liter.

Following this schedule, there should usually be no problem and growers will achieve good yields.

Experienced Grower

Experienced growers usually measure their feeding solution to give the plants the exact amount of nutrients and the correct pH value of the solution.

Whether you grow coconut, hydroponics or aeroponics – with all these systems you should measure your pH and EC values.

When you use a pH and EC meter, you can optimize your cultivation and achieve much better results.

Steps for mixing nutrient solution:

1. a) Check the pH and EC value of the water and make sure the temperature is around 18-22 degrees Celsius. You should also check if your water contains enough Calcium.

1. b) If your EC is 0.0 (using RO or rainwater), add Calcium to your water before adding powder feeding. Make sure your EC rises up to 0.3-0.4 EC

2. Add Powder Feeding and mix well for 2-3 minutes, then measure the EC value. Repeat if necessary until you reach the desired value.

3. Once you have reached the desired EC value, wait for 15-30 min.

4. Then measure the PH and adjust if necessary with PH up or PH down – mix well for 2-3 minutes and wait again 15-30 minutes before measuring.

5. Once you have reached the desired values, feed your plants.